Question regarding PMM parameter setup for a 60-2 input train

All,

I am trying to configure PMM to work in COUNT Mode with input 
generated from a 60 minus 2 crank wheel.

Ultimately I will want to use BANK Mode, but right now I'm bench 
testing and don't have any way synchronize a separate input for the 
bank signal.

I have tried using both 1 and 2 as MAX_MISSING, I have NUM_OF_TEETH 
set to 57 (zero-relative for 58 teeth), I have RATIO set at 1.5 
(approx.), and TCR2_MAX_VALUE also set to 57.

Everything initializes just fine but I can't seem to get things 
synchronized. I suspect the problem is the parameter values, but I 
am also unsure if it is possible to set things up to work with the 
two consecutive missing teeth.

Can someone that has worked with PMM tell me if it will work with 
this 60 minus 2 wheel? If so, what would the correct parameter 
values be? Do I need to make some adjustments on the fly (in the 
interrupt routine) to accommodate the "minus two" pattern?

Thanks very much.

(and thanks again to Eric McRae for helping me find the ERR/TEETH-
COUNT parameters)

-Paul





-----------------------------------------------------------
To learn more about Freescale Microcontrollers, please visit
http://www.freescale.com/mcu


 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/MPC500/

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/