Re: TPU Problem
"spw_lotus" <[email protected]>
| Newsgroups | gmane.comp.hardware.motorola.microcontrollers |
|---|---|
| Message-ID | <[email protected]> |
Hi Eric Output is as below __________________________________________________________ >go 3fa004 TPU Functions Written TPU MCR = a0 TPU MCR = 2400 CFSR3 = 00fe CPR1 = 0003 Enable Measure Func CPR1 = 0007 CFSR3 = 00fe ____________________________________________________________ The square wave output stops at the 'Enable Measure Func' point. Many thanks for your help Eric. Let's hope you can see what I am doing wrong! Best regards Steve --- In [email protected], Eric McRae <eric@e...> wrote: > Can you supply the text output from your program? > > spw_lotus wrote: > > > If you don't mind I will attach my 'C' source code for the program I > > am running. Note that this board is running on an Axiom PB-0555 board > > therefore all of the relevant CPU registers have been initialised by > > the monitor program. As you will see from my program I have inserted > > a number of checks of TPU register values but they all seem to be as > > expected. > > -- > Eric McRae, Electro-Logic Machines, Inc. > 511 Root St., Port Townsend WA, 98368 > Phone/Fax: 360.379.0969, http://www.elmi.com ----------------------------------------------------------- To learn more about Freescale Microcontrollers, please visit http://www.freescale.com/mcu Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/MPC500/ <*> To unsubscribe from this group, send an email to: [email protected] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/