Re: Re: TPU Problem
Eric McRae <[email protected]>
| Newsgroups | gmane.comp.hardware.motorola.microcontrollers |
|---|---|
| Message-ID | <[email protected]> |
OK, your measurement function is OK, I've run it on the ASH WARE
simulator without any problems. Your control registers are fine too.
I'm guessing that your square wave function is depending on DIOB being
unchanged between time slices and that when the measurement function
starts and clobbers DIOB, the wave function flips out.
If this is not the case, can you also supply your square wave function
source?
--
Eric McRae, Electro-Logic Machines, Inc.
511 Root St., Port Townsend WA, 98368
Phone/Fax: 360.379.0969, http://www.elmi.com
-----------------------------------------------------------
To learn more about Freescale Microcontrollers, please visit
http://www.freescale.com/mcu
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/MPC500/
<*> To unsubscribe from this group, send an email to:
[email protected]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/