Re: RS232 to SPI converter.
"David W. Walters" <[email protected]>
| Newsgroups | gmane.comp.hardware.motorola.microcontrollers |
|---|---|
| Message-ID | <[email protected]> |
John, I think what you are looking for is a SPI based UART chip. Maxim makes such a device. It is the MAX3100. Dave Walters Tarascio, Tony wrote: >I'm not aware of any that are commercially manufactured, but I have been in situations where early "check out" (test) of an SPI slave (i.e., before the master code was ready) was desired. An RS232-to-SPI converter enables such a test to be performed. > >You can make one with a small, single-chip PIC microcontroller that has both a serial port and an SPI port, and a minimalist bit of software. This took an afternoon to build, and a day or so to program, in my case. > >Use a DIP switch to configure the SPI parameters, or use a special escape sequence to do so. >I used a serial line BREAK condition to escape a command byte. > >All other bytes (not following a break) were passed through transparently. > >Good luck! > >-----Original Message----- >From: [email protected] [mailto:[email protected]] >Sent: Wednesday, June 22, 2005 1:35 PM >To: [email protected] >Subject: [MPC500] RS232 to SPI converter. > > >Dear friends, > >Could you let me know where I may find RS232 to SPI converter? Your help is greatly appreciated. > > >John > > >----------------------------------------------------------- >To learn more about Freescale Microcontrollers, please visit >http://www.freescale.com/mcu > > > >Yahoo! Groups Links > > > > > > > > > >----------------------------------------------------------- >To learn more about Freescale Microcontrollers, please visit >http://www.freescale.com/mcu > > > >Yahoo! Groups Links > > > > > > > > > > ----------------------------------------------------------- To learn more about Freescale Microcontrollers, please visit http://www.freescale.com/mcu Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/MPC500/ <*> To unsubscribe from this group, send an email to: [email protected] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/