Easiest (and cheapest) interface.
"elderjohnnyboy" <[email protected]>
| Newsgroups | gmane.comp.hardware.motorola.microcontrollers |
|---|---|
| Message-ID | <[email protected]> |
Okay, here's the deal. I'm a ME major at the University of Utah,
and I'm developing a controller board for several robots we have
here. I will be using the MPC565. This has really been a learning
experience. I'm modeling my board after some of the more simple
evaluation boards. My first (many are likely to follow) question is
this:
What is the most user-friendly way to download code to the processor?
Expanded: I am only familiar with the HC11, and I know that the
MPC565 has no bootstrap mode. Is there a bootloader I can implement
in processor flash to accept serially transmitted code and save it
to external flash or ram?
I know that a wiggler will work, but they're surprisingly
expensive. A less expensive option would be better for the budget.
I realize this is quite a leap for me to try to take, but processing
needs have escalated to the point where only the 565 will do. If
any of you could refer me to helpful websites, I would appreciate
it. Thanks in advance!
-----------------------------------------------------------
To learn more about Freescale Microcontrollers, please visit
http://www.freescale.com/mcu
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/MPC500/
<*> To unsubscribe from this group, send an email to:
[email protected]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/