wiggler
"nossnahojleinad" <[email protected]>
| Newsgroups | gmane.comp.hardware.motorola.microcontrollers |
|---|---|
| Message-ID | <[email protected]> |
I am useing a wiggler with power supply to it to program a mpc565
processor.
It doesn't work on all computers, after a while two of them just don't
work. They did fine about 10-20 times.
And one computer work every fifth time I use it, more or less.
Voltages in the paralell port is ~4.6 volt on all computers. So its
not a 3.3 volt as i saw in one another message here.
Now i wonder if there are more known wiggler issues that could cause this?
Otherwise I should start looking at the mpc-board since it's under
development.
And I also wonder if the problem with 3.3 volt in paralellport for
wiggler applies to the version with external powersupply, as in my case?
Thanks for reading!
//Daniel
------------------------ Yahoo! Groups Sponsor --------------------~-->
<font face=arial size=-1><a href="http://us.ard.yahoo.com/SIG=12hjtts59/M=362329.6886308.7839368.1510227/D=groups/S=1706554205:TM/Y=YAHOO/EXP=1124695848/A=2894321/R=0/SIG=11dvsfulr/*http://youthnoise.com/page.php?page_id=1992
">Fair play? Video games influencing politics. Click and talk back!</a>.</font>
--------------------------------------------------------------------~->
-----------------------------------------------------------
To learn more about Freescale Microcontrollers, please visit
http://www.freescale.com/mcu
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/MPC500/
<*> To unsubscribe from this group, send an email to:
[email protected]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/