RE: Torque control in BLDC motor

> I'm doing a torque control project in a BLDC motor. At the moment, I'm
> testing diferent power stages with MC33035P and after I shall do the
> specific torque control.
> I want help to assist with the motor force independently of the speed.

Igor, I'm afraid this forum is the wrong place to ask ... although you might
get lucky and get a response with an answer.  But I would suggest you poke
around on
http://www.embedded.com/searcheetn.jhtml?queryText=motor+torque&site=12
and see what you can find.  I don't even know what a BLDC motor is, but I
know I've seen articles on torque control in PM and stepper motors.

Randall Young
Senior Software Engineer
NavCom Technology, Inc.
A John Deere Company

    "The information contained in or attached to this message, to the extent
it is non-public, is the confidential, proprietary information of NavCom
Technology, Inc., its affiliates
        and/or subsidiaries (collectively, "NavCom") and may not be
reproduced, disclosed to any third party or used by recipient and/or the
recipient's employer (hereinafter
        "recipient"), for other than the intended purpose for which it was
provided to the recipient, or other than in accordance with the terms of any
Confidentiality or Non Disclosure
        Agreement between NavCom. and the recipient, without the prior
written approval of NavCom. If you are not the intended recipient or the
person responsible for delivering the
        electronic mail to the intended recipient, be advised that you have
received this electronic mail in error and that any use, dissemination,
forwarding, printing, or copying of this
        electronic mail is strictly prohibited.  If you have received this
electronic mail in error, please immediately notify the sender by return
mail."



-----------------------------------------------------------
To learn more about Freescale Microcontrollers, please visit
http://www.freescale.com/mcu


 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/MPC500/

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/