RE: Toucan softreset issue

Hello Allan 
I am doing a softreset for the TOUCAN Module during
the bus off interrupt. Is there any possibility of
generating any other kind of interrupt during soft
reset (documented / undocumented ) ? In general how
long it will take to complete the softreset
functionality ? 

The only mistake I did was , I was doing a softreset
on CAN B when detected bussoff in CAN A.  But
according to the documentation , this should not cause
any other issues or interrupts . The
problem(reset,external watchdog) goes away when I
disable interrupts during soft reset .

Regards
Sudhersan


--- Dobbin Allan-r11834 <[email protected]>
wrote:

> Please explain exactly what problems you are seeing.
> 
> - Allan
> 
> -----Original Message-----
> From: [email protected]
> [mailto:[email protected]] On Behalf
> Of Sudhersan Lal
> Sent: Friday, March 24, 2006 7:52 AM
> To: [email protected]
> Subject: [MPC500] Toucan softreset issue
> 
> 
> Hello All 
> I am facing some problems with TOUCAN softreset
> functionality. When I am disabling the interrupts
> during the soft reset , the problems goes away.
> Wondering anybody else has faced this problem before
> ?
> 
> Is there any recommendations like disable interrupts
> during toucan softreset ? Is there any errata
> avaialbe
> with respect to this other than one "CAN: Bus Off
> recovery not ISO compliant" ? 
> Regards
> Sudhersan
> 
> 
> __________________________________________________
> Do You Yahoo!?
> Tired of spam?  Yahoo! Mail has the best spam
> protection around 
> http://mail.yahoo.com 
> 
> 
>
-----------------------------------------------------------
> To learn more about Freescale Microcontrollers,
> please visit
> http://www.freescale.com/mcu
> 
> 
>  
> Yahoo! Groups Links
> 
> 
> 
>  
> 
> 
> 
> 


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 


-----------------------------------------------------------
To learn more about Freescale Microcontrollers, please visit
http://www.freescale.com/mcu


 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/MPC500/

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/