RE: Address lines Pull UP

you must have "show cycles" turned on. This is a debug feature that
allows the addresses of internal accesses to be shown on the external
bus (without asserting a chip select). this allows tools to trace what
the processor is doing.
 
Show Cycles is controlled in the ICTRL register on the MPC500 devices.
The  ISCT_SER bits control this. The default value is 0b000. This should
normally be set to 0b101 or 0b111. See the Reference Manual for more
information.
 
randy

	-----Original Message-----
	From: [email protected] [mailto:[email protected]] On
Behalf Of harini m
	
	   
	  I haven't configured the address lines for SGPIO. So default
is ADD only. And one thing is voltage levels are 3 Volts only not 5
Volts. It means these are address lines. 
	  And one more doubt is generally in any controller data will
not appear on external bus if we are accessing internal address
locations. But in MPC565 we are getting address and data on the
corresponding lines even we are accessing internal address locations.
	



[Non-text portions of this message have been removed]



------------------------ Yahoo! Groups Sponsor --------------------~--> 
Home is just a click away.  Make Yahoo! your home page now.
http://us.click.yahoo.com/DHchtC/3FxNAA/yQLSAA/dN_tlB/TM
--------------------------------------------------------------------~-> 

-----------------------------------------------------------
To learn more about Freescale Microcontrollers, please visit
http://www.freescale.com/mcu


 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
    http://groups.yahoo.com/group/MPC500/

<*> To unsubscribe from this group, send an email to:
    [email protected]

<*> Your use of Yahoo! Groups is subject to:
    http://docs.yahoo.com/info/terms/