Re: Can you tell me a software Tools for MPC5553-54 for code C and code assembler?
James Smith <[email protected]>
| Newsgroups | gmane.comp.hardware.motorola.microcontrollers |
|---|---|
| Message-ID | <[email protected]> |
Hello Jose,
There is a list here:
http://www.ece.ualberta.ca/~jasmith/mpc555/#MPC5500software
-James
On 12-Jun-06, at 4:15 AM, Jose Manuel Ruiz wrote:
> Hello,
>
>
> Can you tell me a software Tools good for MPC5553 and MPC5554 for code
> C and assembler?
>
> Thank you
>
>
>
>
>
>
>
>
>
> -----------------------------------------------------------
> To learn more about Freescale Microcontrollers, please visit
> http://www.freescale.com/mcu
>
>
>
> Yahoo! Groups Links
>
>
>
>
>
>
>
James Andrew Smith
PhD Candidate, Mechanical Engineering
Mechatronic Locomotion Laboratory
McGill University
Web: www.cim.mcgill.ca/~jasmith
Phone: 514-398-8054
------------------------ Yahoo! Groups Sponsor --------------------~-->
Get to your groups with one click. Know instantly when new email arrives
http://us.click.yahoo.com/.7bhrC/MGxNAA/yQLSAA/dN_tlB/TM
--------------------------------------------------------------------~->
-----------------------------------------------------------
To learn more about Freescale Microcontrollers, please visit
http://www.freescale.com/mcu
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/MPC500/
<*> To unsubscribe from this group, send an email to:
[email protected]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/