RE: quick question

Just to prove it out:

::*> aggr show -aggregate * -fields usedsize,size,percent-used -sort-by percent-used

Error: invalid argument "-sort-by"

::*> set diag

Warning: These diagnostic commands are for use by NetApp personnel only.
Do you want to continue? {y|n}: y

::*> aggr show -aggregate * -fields usedsize,size,percent-used -sort-by percent-used
aggregate                percent-used size    usedsize
------------------------ ------------ ------- --------
Aggr1_SSD_2 34%          5.24TB  1.79TB
Aggr1_SSD_1 38%          5.24TB  1.99TB
Aggr2_SSD_2 42%          5.24TB  2.21TB
Aggr2_SSD_1 44%          5.24TB  2.32TB

From: Parisi, Justin
Sent: Thursday, September 3, 2020 10:32 AM
To: Scott Eno <[email protected]>; Toasters <[email protected]>
Subject: RE: quick question

Use diag priv.

From: Scott Eno <[email protected]<mailto:[email protected]>>
Sent: Thursday, September 3, 2020 10:13 AM
To: Toasters <[email protected]<mailto:[email protected]>>
Subject: quick question

Just checking, does "-sort-by" still work?

cluster::*> storage aggregate show -aggregate * -fields usedsize,size,percent-used -sort-by percent-used

Error: invalid argument "-sort-by"

_______________________________________________
Toasters mailing list
[email protected]
https://www.teaparty.net/mailman/listinfo/toasters