RE: quick question
"John Stoffel" <[email protected]>
| Newsgroups | gmane.comp.hardware.netapp |
|---|---|
| Message-ID | <[email protected]> |
>>>>> "Justin" == Justin Parisi <[email protected]> writes: So why is this a diag only command? Does it take too much CPU to sort by specific fields? Seems like a fantastic thing to have in regular mode for sure. Justin> Just to prove it out: Justin> ::*> aggr show -aggregate * -fields usedsize,size,percent-used -sort-by percent-used Justin> Error: invalid argument "-sort-by" Justin> ::*> set diag Justin> Warning: These diagnostic commands are for use by NetApp personnel only. Justin> Do you want to continue? {y|n}: y Justin> ::*> aggr show -aggregate * -fields usedsize,size,percent-used -sort-by percent-used Justin> aggregate percent-used size usedsize Justin> ------------------------ ------------ ------- -------- Justin> Aggr1_SSD_2 34% 5.24TB 1.79TB Justin> Aggr1_SSD_1 38% 5.24TB 1.99TB Justin> Aggr2_SSD_2 42% 5.24TB 2.21TB Justin> Aggr2_SSD_1 44% 5.24TB 2.32TB Justin> From: Parisi, Justin Justin> Sent: Thursday, September 3, 2020 10:32 AM Justin> To: Scott Eno <[email protected]>; Toasters <[email protected]> Justin> Subject: RE: quick question Justin> Use diag priv. Justin> From: Scott Eno <[email protected]> Justin> Sent: Thursday, September 3, 2020 10:13 AM Justin> To: Toasters <[email protected]> Justin> Subject: quick question Justin> Just checking, does "-sort-by" still work? Justin> cluster::*> storage aggregate show -aggregate * -fields usedsize,size,percent-used -sort-by Justin> percent-used Justin> Error: invalid argument "-sort-by" Justin> _______________________________________________ Justin> Toasters mailing list Justin> [email protected] Justin> https://www.teaparty.net/mailman/listinfo/toasters