statistics show-periodic
Mike Thompson <[email protected]> Thu, 21 Oct 2021 22:48:48 -0700
| Newsgroups | gmane.comp.hardware.netapp |
|---|---|
| Message-ID | <CAJrU+zjmO+1ZWB03QiJ=Heds2Vfr=158W-ic4B8WHCMjPY5b1w@mail.gmail.com> |
can't seem to get this to work on a 9.7 box. works fine on 9.3
am I missing something obvious?
pd-san2::*> set -privilege advanced
pd-san2::*> statistics show-periodic -counter
total-recv|total-sent|data-recv|data-sent|cluster-recv|cluster-sent|cluster-busy
Error: command failed: entry doesn't exist
pd-san2::*> set -privilege diag
Warning: These diagnostic commands are for use by NetApp personnel only.
Do you want to continue? {y|n}: y
pd-san2::*> statistics show-periodic -counter
total-recv|total-sent|data-recv|data-sent|cluster-recv|cluster-sent|cluster-busy
Error: command failed: entry doesn't exist
pd-san2::*> version
NetApp Release 9.7P13: Thu Apr 15 02:06:46 UTC 2021
_______________________________________________
Toasters mailing list
[email protected]
https://www.teaparty.net/mailman/listinfo/toasters