Re: statistics show-periodic

Potocky Miroslav <[email protected]> Fri, 22 Oct 2021 08:40:09 +0200
Newsgroups gmane.comp.hardware.netapp
Message-ID <[email protected]>
Seems to work fine on 9.7P11. Maybe a more recent change?

XXXX::> set -privilege advanced

Warning: These advanced commands are potentially dangerous; use them 
only when directed to do so by NetApp personnel.
Do you want to continue? {y|n}: y

XXXX::*>  statistics show-periodic -counter 
total-recv|total-sent|data-recv|data-sent|cluster-recv|cluster-sent|cluster-busy
XXXX: cluster.cluster: 10/22/2021 08:36:25
     total    total     data     data cluster  cluster  cluster
      recv     sent     recv     sent    busy     recv     sent
  -------- -------- -------- -------- ------- -------- --------
    2.91GB   4.08GB    735MB   2.09GB     51%   2.19GB   1.99GB
    3.19GB   4.79GB    836MB   2.34GB     40%   2.37GB   2.44GB
XXXX: cluster.cluster: 10/22/2021 08:36:30
     total    total     data     data cluster  cluster  cluster
      recv     sent     recv     sent    busy     recv     sent
  -------- -------- -------- -------- ------- -------- --------
Minimums:
    2.91GB   4.08GB    735MB   2.09GB     40%   2.19GB   1.99GB
Averages for 2 samples:
    3.05GB   4.43GB    786MB   2.22GB     45%   2.28GB   2.22GB
Maximums:
    3.19GB   4.79GB    836MB   2.34GB     51%   2.37GB   2.44GB


XXXX::*> version
NetApp Release 9.7P11: Tue Jan 12 23:00:49 UTC 2021

Regards,
MP

On 22. 10. 2021 7:48, Mike Thompson wrote:
>
> can't seem to get this to work on a 9.7 box.   works fine on 9.3
>
> am I missing something obvious?
>
> pd-san2::*> set -privilege advanced
>
> pd-san2::*> statistics show-periodic -counter 
> total-recv|total-sent|data-recv|data-sent|cluster-recv|cluster-sent|cluster-busy
>
> Error: command failed: entry doesn't exist
>
> pd-san2::*> set -privilege diag
>
> Warning: These diagnostic commands are for use by NetApp personnel only.
> Do you want to continue? {y|n}: y
>
> pd-san2::*> statistics show-periodic -counter 
> total-recv|total-sent|data-recv|data-sent|cluster-recv|cluster-sent|cluster-busy
>
> Error: command failed: entry doesn't exist
>
> pd-san2::*> version
> NetApp Release 9.7P13: Thu Apr 15 02:06:46 UTC 2021
>
> _______________________________________________
> Toasters mailing list
> [email protected]
> https://www.teaparty.net/mailman/listinfo/toasters

_______________________________________________
Toasters mailing list
[email protected]
https://www.teaparty.net/mailman/listinfo/toasters
smime.p7s (application/pkcs7-signature, 5.5 KB) - not displayed