Problem with booting on a USB memory key when IDE is on

Carsten Skov <[email protected]> Wed, 04 Feb 2004 21:17:32 +0100

Newsgroups	gmane.comp.hardware.openbrick.general
Message-ID	<1075925852.3029.8.camel@localhost>

Hello!

I have been trying to upgrade my Openbrick E, by cat'ing network.img to
a USB memory key. But as long as the IDE interface is enabled in the
BIOS it will not boot on the key, but jumps to the linux bootloader
located on the harddrive.

Anyone have an idea as to why?

Best regards
Carsten Skov