Re: Programming size
Scott Henion <[email protected]>
| Newsgroups | gmane.comp.hardware.rabbit-semiconductor |
|---|---|
| Message-ID | <[email protected]> |
On 9/28/2012 2:08 PM, seecwriter wrote:
> This is something I probably knew at one point but don't remember.
> When you program a Rabbit module, RCM3000 in this case, using the RFU, does something other than the rabbit binary get programmed into the flash?
> I have a binary file that is 522,882 bytes, but the RFU says it sent 529,228 bytes. I thought the Rabbit BIOS was part of the binary file. Is there something else going on that I forgot?
The serial boot only allows loading to RAM. There is a cold loader that
is loaded to RAM that does the programming to flash. The RFU includes it
in the size.
--
------------------------------------------
Scott G. Henion, Consultant
Web site: http://SHDesigns.org
------------------------------------------