Re: Re: PortB question

Which module are you using?

On 3/4/2013 9:52 PM, Sylvain Bissonnette wrote:
>
>
> No I check and that's not the problem, the pin is stuck high
>
> On Mon, Mar 4, 2013 at 12:49 AM, seecwriter <seecwriter-/[email protected]
> <mailto:seecwriter-/[email protected]>> wrote:
>
>      
>
>     Does Port B have the option to be open-collector? If so, is that
>     set correctly?
>
>     --- In [email protected]
>     <mailto:rabbit-semi%40yahoogroups.com>, Sylvain Bissonnette wrote:
>     >
>     > Hi, I have a problem with the PORTB bit 0 I set this bit in
>     output and I
>     > write values but without success I don't get anything from the I/O.
>     >
>     > for (i=0;i<8;i++) BitWrPortI(PBDDR,&PBDDRShadow,1,i);
>     >
>     > while(1) WrPortI(PBDR, &PBDRShadow,i++);
>     >
>     > Thanks for your time
>     > Sylvain Bissonnette
>     >
>
>
>
>
> 


-- 
------------------------------------------
     Scott G. Henion, Consultant
Web site:    http://SHDesigns.org
------------------------------------------