Re: Re: PortB question

MicroCore RCM6700

On Tue, Mar 5, 2013 at 3:34 AM, Scott Henion <[email protected]> wrote:

> **
>
>
> Which module are you using?
>
> On 3/4/2013 9:52 PM, Sylvain Bissonnette wrote:
>
> No I check and that's not the problem, the pin is stuck high
>
> On Mon, Mar 4, 2013 at 12:49 AM, seecwriter <seecwriter-/[email protected]> wrote:
>
>>
>>
>> Does Port B have the option to be open-collector? If so, is that set
>> correctly?
>>
>> --- In [email protected], Sylvain Bissonnette wrote:
>> >
>> > Hi, I have a problem with the PORTB bit 0 I set this bit in output and I
>> > write values but without success I don't get anything from the I/O.
>> >
>> > for (i=0;i<8;i++) BitWrPortI(PBDDR,&PBDDRShadow,1,i);
>> >
>> > while(1) WrPortI(PBDR, &PBDRShadow,i++);
>> >
>> > Thanks for your time
>> > Sylvain Bissonnette
>> >
>>
>>
>
>
> --
> ------------------------------------------
>      Scott G. Henion, Consultant
> Web site:    http://SHDesigns.org
> ------------------------------------------
>
>  
>