RE: Re: Rabbit 2000 and Dynamic C 10
"Fournier, Peter" <pfournier-P4RXiKWKZulWk0Htik3J/[email protected]>
| Newsgroups | gmane.comp.hardware.rabbit-semiconductor |
|---|---|
| Message-ID | <[email protected]> |
Are you sure you do not already effectively have 2 stop bits? Some processors are slow enough between bytes that there can be a whole extra stop bit between bytes without you adding one in. -Pete F -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of ricardoparanabr Sent: Monday, April 01, 2013 10:18 AM To: [email protected] Subject: [rabbit-semi] Re: Rabbit 2000 and Dynamic C 10 I´m asking because a have an old project using RCM2200 and my main cliente want to use 2 stop bits on serial comunicacion. --- In [email protected], Scott Henion <shenion@...> wrote: > > On 3/28/2013 10:06 AM, ricardoparanabr wrote: > > Hi all, > > > > can I use Dymanic C 10 with my old project with rabbit 2000 ? > > (RCM2200) or are there any new module pin compatible with RCM2200 ? > > > > Dynamic C 10 only supports 4000, 5000 and 6000 series processors. you > need 9.x for 2000 and 3000 series (9.62 is current version.) > > Newer modules use entirely different form factors. > > > -- > ------------------------------------------ > Scott G. Henion, Consultant > Web site: http://SHDesigns.org > ------------------------------------------ > ------------------------------------ Yahoo! Groups Links