Re: RE: TCP sequence numbers.
Steve Trigero <seecwriter-/[email protected]>
| Newsgroups | gmane.comp.hardware.rabbit-semiconductor |
|---|---|
| Message-ID | <[email protected]> |
I assume to mean to turn off auto-negotiation and auto-crossover in the switch, since I don't see that option in the DC libraries. Why do think these modes could be causing the problem? Are you thinking the switch is changing the crossover configuration during communication, or losing the negotiated comm settings? Steve On Sunday, January 26, 2014 11:57 PM, "[email protected]" <[email protected]> wrote: >Hi Steve, > > >I had a similar problem last year. > >Try to turn off automatic crossover ("auto MDI-X" or "auto-uplink") of the Rabbit ethernet port (you can try with the switch ports also, if there is such option at all). > > >Turn off auto negotiation too. Make sure to configure the right transmission parameters, such as speed, duplex mode, and flow control. > > >Wish you success with this annoying eth problem, >Alexander Hristov > > > > > > >