RE: RE: TCP sequence numbers.
"Huynh, Henry" <[email protected]>
| Newsgroups | gmane.comp.hardware.rabbit-semiconductor |
|---|---|
| Message-ID | <[email protected]> |
Hello, You meant “Turning off automatic crossover “ the port of the Rabbit board?, if so, could you show me how. Thanks Henry Huynh From: [email protected] [mailto:[email protected]] On Behalf Of [email protected] Sent: Monday, January 27, 2014 2:57 AM To: [email protected] Subject: [rabbit-semi] RE: TCP sequence numbers. Hi Steve, I had a similar problem last year. Try to turn off automatic crossover ("auto MDI-X" or "auto-uplink") of the Rabbit ethernet port (you can try with the switch ports also, if there is such option at all). Turn off auto negotiation too. Make sure to configure the right transmission parameters, such as speed, duplex mode, and flow control. Wish you success with this annoying eth problem, Alexander Hristov
image001.jpg
(image/jpeg, 359 B) - not displayed
image002.jpg
(image/jpeg, 332 B) - not displayed