Re: How to 'recover' or pull a program from the board
| Newsgroups | gmane.comp.hardware.rabbit-semiconductor |
|---|---|
| Message-ID | <CAL8BBoOcm6-Rn1BXLvC+r4b2+Mq0MDBmMeiBhjy=xLT8v4U2sQ@mail.gmail.com> |
How broken is the hard drive, Mechanical Failure or just wouldnt boot? have you tried mounting the drive on another system, chances are if you can mount it you can recover the files you want. You can get USB-->IDE/SATA adaptors that make plugging in a drive a lot easier. On 22 January 2015 at 15:11, Phil D <[email protected]> wrote: > Not sure of you can pull firmware from device. > Even if you can you would end up with the compiled files from DC which > wouldnt give you your original program back in an easily > editable/re-compilable form > > On 22 January 2015 at 11:21, [email protected] [rabbit-semi] < > [email protected]> wrote: > >> >> >> Hi All, >> >> I'm looking for some help. My PC crashed (HDD failed) and i had made no >> backups of my program (yep, school boy error). So rather than starting >> afresh i was wondering if theres a way to pull the program from my board >> back into DC. >> >> I'm running with RCM3200's >> >> Help or advise is much appreciated! >> >> > >