Re: How to 'recover' or pull a program from the board

"Phil D [email protected] [rabbit-semi]" <[email protected]>
Newsgroups gmane.comp.hardware.rabbit-semiconductor
Message-ID <CAL8BBoM_=MKXnrzrnKhbYW=A7CD8uNz7GmmKCfMo=8ydHehzyQ@mail.gmail.com> 
Not sure of you can pull firmware from device.
Even if you can you would end up with the compiled files from DC which
wouldnt give you your original program back in an easily
editable/re-compilable form

On 22 January 2015 at 11:21, [email protected] [rabbit-semi] <
[email protected]> wrote:

>
>
> Hi All,
>
> I'm looking for some help. My PC crashed (HDD failed) and i had made no
> backups of my program (yep, school boy error). So rather than starting
> afresh i was wondering if theres a way to pull the program from my board
> back into DC.
>
> I'm running with RCM3200's
>
> Help or advise is much appreciated!
>  
>
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.