Re: RCM3700

"S Sutikno [email protected] [rabbit-semi]" <[email protected]> Wed, 24 Feb 2016 14:05:37 +0700

Newsgroups	gmane.comp.hardware.rabbit-semiconductor
Message-ID	<CAPWahUe_=rEXgc27PGUS_DhVZ+8es28QK7Ndj2bu2jhtFwPpbg@mail.gmail.com>

Tom, thanks for your attention.

Problem already solved. I'm make mistake on my software, cs for adc always
low.

Regards,
Stev

On Wed, Feb 24, 2016 at 5:51 AM, Tom Collins tom-lnEA/wrDJtNWk0Htik3J/[email protected] [rabbit-semi]
<[email protected]> wrote:

>
>
> Stev,
>
> Please email me your test code off-list (tom-lnEA/wrDJtNWk0Htik3J/[email protected]) and I'll take
> a look at it when I'm back in the office later this week.  I'd like to see
> an example program that has valid ADC readings until it accesses the serial
> flash.  My goal will be to make updates to the program or libraries so the
> ADC continues working after reading/writing the serial flash.
>
> -Tom
>
>
> On Feb 21, 2016, at 9:24 PM, S Sutikno [email protected] [rabbit-semi]
> wrote:
>
> Dear Tom,
>
> I'm already upgrade to DC 9.62 and same result, ADC value still 0.
>
> I'm use RCM37xx.lib included in folder sample/rcm3700 and sflash.lib.
> Thanks.
> Stev
>
>
> 
>