Re: Motherboard design for RCM6700 series

Racq,

I think the RCM6700 manual includes a design guide section with things to be careful of, and in the past you could download schematics for the development boards.

I'd be very careful with the schematic and layout for the Ethernet connection in particular, and the physical layout of the for the Minicore module connectors.  I believe you can buy small quantities of the Minicore connector from the digi.com website.

-Tom


On Mar 18, 2016, at 3:00 PM, Steve Trigero seecwriter-/[email protected] [rabbit-semi] wrote:

> 
> You shouldn't have much difficulty. It's fairly straight forward. IMO, professional help (consultant) would be overkill.
> 
> 
> From: "[email protected] [rabbit-semi]" <[email protected]>
> To: [email protected] 
> Sent: Friday, March 18, 2016 8:18 AM
> Subject: [rabbit-semi] Motherboard design for RCM6700 series
> 
>  
> I have less than 2 years experience in hardware designing and I was assign to use the schematics for the RCM6700 on digi.com to design necessary documents needed to manufacture 10- 15 mother/interface board.  This board must have 3 UART, backup, and a Ethernet port.  How difficult is it to accomplish this task with my level of experience?  Or should I seek professional help, if so where?  Thanks
> 
> Racq
> 
> 
> 
> 
> _.
>  
> 
>