| Newsgroups |
gmane.comp.hardware.soekris.technical |
| Message-ID |
<CAHRGjuHme09u2BhQYO5a86Gu3qHgvzrWaoF_0zdWMM-HYe7Luw@mail.gmail.com> |
Hello,
I am still unable to create a raid 1 that includes the second SSD on either
of my net6501 and strongly suspect a bios or hardware fault, anyone else
experiencing the same issue ?
Thank you,
Dan
On Sun, Jun 22, 2014 at 1:25 PM, Dan Podeanu <[email protected]> wrote:
>
> I have just received two net6501-70 with identical configurations:
>
> - net6501-70 Board and 1 Slot Standard Case
> - Intel 30GB MLC mSATA SSD - SSDMCEAC030B3 (2 per box - for software RAID
> 1)
> - lan1841, PCI Express Quad Gigabit ethernet board
>
> While installing Linux x32 (3.15.1), during the initial software raid
> setup the second mSATA (scsi 1:0:0:0) drops out of raid after a few minutes
> of raid building. The behavior is 100% reproducible on both boxes.
> Furthermore, after encountering the error and soft-rebooting, the BIOS no
> longer sees the second mSATA drive (it does NOT appear in comBIOS device
> listing)- a hardware reboot (i.e. from button) or power cycle makes the
> disk available again.
>
> The first mSATA (scsi 0:0:0:0) is stable.
>
> The distro is Linux Gentoo i686 and I can reproduce it with both the
> supplied kernel or custom compiled. I can provide .config and any and all
> other information, or try anything you might suggest in order to further
> debug the issue.
>
> Details below; please advise.
>
> Thank you,
> Dan
>
>
> uname:
>
> Linux speedy 3.15.1-net6501 #1 SMP PREEMPT Sat Jun 21 20:21:31 UTC 2014
> i686 Genuine Intel(R) CPU @ 1.60GHz GenuineIntel GNU/Linux
>
> dmesg error snippet:
>
> Jun 21 21:49:58 speedy kernel: [ 2045.111438] ata2.00: exception Emask
> 0x10 SAct 0x18000 SErr 0x10300 action 0xe frozen
> Jun 21 21:49:58 speedy kernel: [ 2045.111447] ata2.00: irq_stat
> 0x08400000, interface fatal error, PHY RDY changed
> Jun 21 21:49:58 speedy kernel: [ 2045.111454] ata2: SError: { UnrecovData
> Persist PHYRdyChg }
> Jun 21 21:49:58 speedy kernel: [ 2045.111462] ata2.00: failed command:
> WRITE FPDMA QUEUED
> Jun 21 21:49:58 speedy kernel: [ 2045.111475] ata2.00: cmd
> 61/00:78:00:66:f4/04:00:00:00:00/40 tag 15 ncq 524288 out
> Jun 21 21:49:58 speedy kernel: [ 2045.111475] res
> 40/00:78:00:66:f4/00:00:00:00:00/40 Emask 0x10 (ATA bus error)
> Jun 21 21:49:58 speedy kernel: [ 2045.111482] ata2.00: status: { DRDY }
> Jun 21 21:49:58 speedy kernel: [ 2045.111488] ata2.00: failed command:
> WRITE FPDMA QUEUED
> Jun 21 21:49:58 speedy kernel: [ 2045.111500] ata2.00: cmd
> 61/80:80:00:6a:f4/03:00:00:00:00/40 tag 16 ncq 458752 out
> Jun 21 21:49:58 speedy kernel: [ 2045.111500] res
> 40/00:78:00:66:f4/00:00:00:00:00/40 Emask 0x10 (ATA bus error)
> Jun 21 21:49:58 speedy kernel: [ 2045.111507] ata2.00: status: { DRDY }
> Jun 21 21:49:58 speedy kernel: [ 2045.111517] ata2: hard resetting link
> Jun 21 21:49:59 speedy kernel: [ 2046.093300] ata2: SATA link up 3.0 Gbps
> (SStatus 123 SControl 300)
> Jun 21 21:49:59 speedy kernel: [ 2046.108273] ata2.00: configured for
> UDMA/133
> Jun 21 21:49:59 speedy kernel: [ 2046.108319] ata2: EH complete
> . . .
> Jun 21 21:50:01 speedy kernel: [ 2048.015017] ata2: SATA link down
> (SStatus 0 SControl 300)
> Jun 21 21:50:06 speedy kernel: [ 2053.014228] ata2: hard resetting link
> Jun 21 21:50:06 speedy kernel: [ 2053.319216] ata2: SATA link down
> (SStatus 0 SControl 300)
> Jun 21 21:50:06 speedy kernel: [ 2053.319239] ata2: limiting SATA link
> speed to 1.5 Gbps
> Jun 21 21:50:11 speedy kernel: [ 2058.318433] ata2: hard resetting link
> Jun 21 21:50:12 speedy kernel: [ 2058.623403] ata2: SATA link down
> (SStatus 0 SControl 310)
> Jun 21 21:50:12 speedy kernel: [ 2058.623423] ata2.00: disabled
> Jun 21 21:50:12 speedy kernel: [ 2058.623474] sd 1:0:0:0: [sdb]
> Jun 21 21:50:12 speedy kernel: [ 2058.623479] Result: hostbyte=0x00
> driverbyte=0x08
> Jun 21 21:50:12 speedy kernel: [ 2058.623485] sd 1:0:0:0: [sdb]
> Jun 21 21:50:12 speedy kernel: [ 2058.623488] Sense Key : 0xb [current]
> [descriptor]
> Jun 21 21:50:12 speedy kernel: [ 2058.623495] Descriptor sense data with
> sense descriptors (in hex):
> Jun 21 21:50:12 speedy kernel: [ 2058.623499] 72 0b 00 00 00 00 00
> 0c 00 0a 80 00 00 00 00 00
> Jun 21 21:50:12 speedy kernel: [ 2058.623518] 00 f5 c2 80
> Jun 21 21:50:12 speedy kernel: [ 2058.623527] sd 1:0:0:0: [sdb]
> Jun 21 21:50:12 speedy kernel: [ 2058.623531] ASC=0x0 ASCQ=0x0
> Jun 21 21:50:12 speedy kernel: [ 2058.623536] sd 1:0:0:0: [sdb] CDB:
> Jun 21 21:50:12 speedy kernel: [ 2058.623540] cdb[0]=0x2a: 2a 00 00 f5 c2
> 80 00 04 00 00
> Jun 21 21:50:12 speedy kernel: [ 2058.623556] end_request: I/O error, dev
> sdb, sector 16106112
> Jun 21 21:50:12 speedy kernel: [ 2058.623622] sd 1:0:0:0: rejecting I/O to
> offline device
> Jun 21 21:50:12 speedy kernel: [ 2058.623630] sd 1:0:0:0: [sdb] killing
> request
> Jun 21 21:50:12 speedy kernel: [ 2058.623645] sd 1:0:0:0: rejecting I/O to
> offline device
> Jun 21 21:50:12 speedy kernel: [ 2058.623694] sd 1:0:0:0: [sdb]
> Jun 21 21:50:12 speedy kernel: [ 2058.623699] Result: hostbyte=0x00
> driverbyte=0x08
> Jun 21 21:50:12 speedy kernel: [ 2058.623704] sd 1:0:0:0: [sdb]
> . . .
> Jun 21 21:50:12 speedy kernel: [ 2058.623978] end_request: I/O error, dev
> sdb, sector 16108160
> Jun 21 21:50:12 speedy kernel: [ 2058.624011] ata2.00: detaching (SCSI
> 1:0:0:0)
> Jun 21 21:50:12 speedy kernel: [ 2058.631674] sd 1:0:0:0: [sdb]
> Synchronizing SCSI cache
> Jun 21 21:50:12 speedy kernel: [ 2058.631818] sd 1:0:0:0: [sdb]
> Jun 21 21:50:12 speedy kernel: [ 2058.631827] Result: hostbyte=0x04
> driverbyte=0x00
> Jun 21 21:50:12 speedy kernel: [ 2058.631835] sd 1:0:0:0: [sdb] Stopping
> disk
> Jun 21 21:50:12 speedy kernel: [ 2058.631875] sd 1:0:0:0: [sdb] START_STOP
> FAILED
> Jun 21 21:50:12 speedy kernel: [ 2058.631885] sd 1:0:0:0: [sdb]
> Jun 21 21:50:12 speedy kernel: [ 2058.631891] Result: hostbyte=0x04
> driverbyte=0x00
>
> dmesg boot snippet:
>
> Jun 21 21:07:36 speedy kernel: [ 4.260721] ata2: SATA link up 3.0 Gbps
> (SStatus 123 SControl 300)
> Jun 21 21:07:36 speedy kernel: [ 4.271704] ata2.00: ATA-9: INTEL
> SSDMCEAC030B3, LLLi, max UDMA/133
> Jun 21 21:07:36 speedy kernel: [ 4.271704] ata2.00: 58626288 sectors,
> multi 16: LBA48 NCQ (depth 31/32), AA
> Jun 21 21:07:36 speedy kernel: [ 4.281700] ata2.00: configured for
> UDMA/133
> Jun 21 21:07:36 speedy kernel: [ 4.281927] scsi 1:0:0:0: Direct-Access
> ATA INTEL SSDMCEAC03 LLLi PQ: 0 ANSI: 5
> Jun 21 21:07:36 speedy kernel: [ 4.283428] sd 1:0:0:0: [sdb] 58626288
> 512-byte logical blocks: (30.0 GB/27.9 GiB)
> Jun 21 21:07:36 speedy kernel: [ 4.283701] sd 1:0:0:0: [sdb] Write
> Protect is off
> Jun 21 21:07:36 speedy kernel: [ 4.283707] sd 1:0:0:0: [sdb] Mode
> Sense: 00 3a 00 00
> Jun 21 21:07:36 speedy kernel: [ 4.283790] sd 1:0:0:0: [sdb] Write
> cache: enabled, read cache: enabled, doesn't support DPO or FUA
> Jun 21 21:07:36 speedy kernel: [ 4.284545] sd 1:0:0:0: Attached scsi
> generic sg1 type 0
> Jun 21 21:07:36 speedy kernel: [ 4.284692] sdb: unknown partition table
> Jun 21 21:07:36 speedy kernel: [ 4.285311] sd 1:0:0:0: [sdb] Attached
> SCSI disk
_______________________________________________
Soekris-tech mailing list
[email protected]
http://lists.soekris.com/mailman/listinfo/soekris-tech