Re: MSP430F5528 - Clock and UART
| Newsgroups | gmane.comp.hardware.texas-instruments.msp430.discuss |
|---|---|
| Organization | State of Total Disorganization |
| Message-ID | <[email protected]> |
On 02/17/2015 09:51 AM, [email protected] [msp430] wrote: > The clock configuration below is used with MCLK = 25 MHz ( when I use it > with MCLK=16 MHz I cannot communicate with the UART module at all ) . How accurate is the clock frequency? Unless you are using a crystal, and it looks like you aren't, the answer could be "not accurate enough". -- David W. Schultz http://home.earthlink.net/~david.schultz Returned for Regrooving ------------------------------------ Posted by: "David W. Schultz" <[email protected]> ------------------------------------ To unsubscribe from the msp430 group, send an email to: [email protected]