Re: Asm source code page?

On Mon, 11 Jan 2016 19:13:53 -0500, Ezra wrote:

>i had a crash and in 2 computers a very big storm with lightnings so everything is lost
>but i have some programmed chips that i uploaded from them an  image as TI-txt  files
>can i disassemble them with kickstart

I think so. I recall that there are a few file formats that
IAR's debugger supports, for loading as code/data. However,
I'm not sure about the TI-txt format you mentioned. You may
need to do some "adjustments" to the formatting in order to
get the debugger (actually, probably the simulator instead so
that you don't need to actually hook up any real device at
the time) to load the code and become accessible for a
disassembly listing output. But I think you can succeed.

One I get the newest tools downloaded from IAR and loaded
onto this machine, I can perhaps do a better job of
suggesting specific things to try out here. But right now
it's just been too long and I forget where to look. But I
seem to recall some file format drop down boxes for the
simulator. That's where I'd try looking, first.

Jon


------------------------------------
Posted by: Jon Kirwan <[email protected]>
------------------------------------

To unsubscribe from the msp430 group, send an email to:
[email protected]