Re: MSP-FET430UIF and mspdebug
Sarfraz Nawaz <[email protected]>
| Newsgroups | gmane.comp.hardware.texas-instruments.msp430.gcc.user |
|---|---|
| Message-ID | <CACDibgFWO9aFefO04ToH6jONnoWr8DBdsk_3mNtwmspzm+OSQA@mail.gmail.com> |
Hi Daniel, I thought about it but the board probably requires more than the 60mA that FET can source, so I decided against it. Do you know if there is protection available on FET against larger source currents? Thanks On Tue, Mar 4, 2014 at 8:20 PM, Daniel Beer <[email protected]> wrote: > On Tue, Mar 04, 2014 at 11:11:58AM +0000, Sarfraz Nawaz wrote: >> It is an evaluation board that is powered by a small Lithium polymer >> battery with a 3V regulator. I have checked that pin number 4 of the >> 14-pin JTAG connector is at 3V with the FET cable connected to the >> board but I still get the same error. Any ideas where I should look >> next please? Thanks. > > Hi Sarfraz, > > Have you tried debugging with the board powered by the FET, rather than > the battery? > > Cheers, > Daniel > > -- > Daniel Beer <[email protected]> www.dlbeer.co.nz > IRC: inittab (Freenode) PGP key: 2048D/160A553B ------------------------------------------------------------------------------ Subversion Kills Productivity. Get off Subversion & Make the Move to Perforce. With Perforce, you get hassle-free workflows. Merge that actually works. Faster operations. Version large binaries. Built-in WAN optimization and the freedom to use Git, Perforce or both. Make the move to Perforce. http://pubads.g.doubleclick.net/gampad/clk?id=122218951&iu=/4140/ostg.clktrk