Re: PPM can't access ppm4.log and perltoc.html

"Eric Robertson" <[email protected]>
Newsgroups gmane.comp.ide.komodo.general
Message-ID <839B9DDA710C4326843E20BAC63721FF@Time>
Many thanks Trent & Jan for the suggestions.

I both renamed the ppm4.log file and ran sudo ppm from the Terminal and then
reinstalled the module I'd problems with and this time there were no error
messages in the PPM console, and there were entries in the ppm4.log.

There doesn't seem to be any change though in perltoc.html as there's still
no entry for the new module but I hadn't renamed that file. I'll have to try
that to do that now but as I'm just going away for a few days it'll have to
wait until I return.

Regards
Eric R


  -----Original Message-----
  From: Jan Dubois [mailto:[email protected]]
  Sent: Wednesday, February 11, 2009 7:24 AM
  To: 'Trent Mick'; 'Eric Robertson'
  Cc: [email protected]
  Subject: RE: [Komodo-discuss] PPM can't access ppm4.log and perltoc.html
  
  On Tue, 10 Feb 2009, Trent Mick wrote:
  > Eric Robertson wrote:
  > > I have Komodo 5.03 and Perl 5.8 on my Mac and I was installing the
  > > module CGI::Session using ppm from the Tools/Run Command. The module
  > > seemed to install OK but I did get a couple of errors - "Can't log
  > > to .../ppm4.log" and a similar one for perltoc.html. I looked at the
  > > latter and couldn't find any entry for this new module, which
  > > presumably should have been there.
  > >
  > > I looked at the permissions for perltoc.html and these showed as
  > > Read & Write for system but only Read for admin and everyone so I
  > > changed that so that all showed Read & Write and reran the
  > > installation again but I still got the same error. I had done a
  > > similar thing for ppm4.log but for that file there was no entry for
  > > the owner so I couldn't change this.
  > >
  > > I assume that this is a permissions problem but how do I change it
  > > so that ppm can access these two files?
  
  You should be able to just delete these files (or maybe rename, to be on
  the safe side).  When you then install another package using PPM these
  files should get re-created with the proper ownership.
  
  Cheers,
  -Jan



_______________________________________________
Komodo-discuss mailing list
[email protected]
To unsubscribe: http://listserv.ActiveState.com/mailman/mysubs
Other options: http://listserv.ActiveState.com/mailman/listinfo/Komodo-discuss
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.