Re: [JMeter] JUnit sampler sample time changes

I see the nanotime. But the time in the sampler results is reported in ms. So when you have you data 
it just says 0. I would like it to go one further and report a low level.

Regards
On 2 Apr 2011, at 16:18, sebb wrote:

> On 31 March 2011 19:41, Ben Cuthbert <[email protected]> wrote:
>> All
>> 
>> I have been looking over the code in the JUnitSampler code under the jmeter source.
>> I would like to make a change to use nanoTime() rather than milliseconds.
> 
> Why?
> 
>> I can see in the AnnotatedTestCase there is an elapsed time. But I can't see how it
>> is returned to a results table. Any ideas?
> 
> The time in AnnotatedTestCase is only used for reporting timeout errors.
> 
> The actual sample time is calculated using SampleResult.sampleStart()
> and sampleEnd() which already use nanoTime().
> 
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: [email protected]
> For additional commands, e-mail: [email protected]
>