User/Group issues

I'm getting a couple odd responses from the administration application:

1) I created a new user using the admin application, but it does not
show up in the drop down list on the worklist management tab.  Is there
a limit to the number of users that can appear in the "Select User" drop
down.  I have verified the user is properly set up in the UserTable,
UserGroupTable, and the GroupTable.

2) I created two users and assigned them both to "GroupTwo".  In the
User Management tab (of the administration application), I mapped the
processes first participant to "GroupOne" and second participant to
"GroupTwo".

When I look a the first user's worklist, I see the processes that are
currently assigned to "GroupTwo" because that user is a member of that
group.  But when I look at the second user's worklist, I do not see
anything.  Again, I compared the UserTable, GroupTable, and
UserGroupTable and do not see anything suspicious

3) I created a user and assigned it to both "GroupOne" and "GroupTwo".
But this user only sees records assigned to GroupTwo, it never sees the
GroupOne records.  However, a user assigned to GroupOne only CAN see the
GroupOne records?

Again, I see nothing funny in the User or Group tables.

Thanks
Greg
******* Confidentiality Notice *******
This email, its electronic document attachments, and the contents of its website linkages may contain confidential health information.  This information is intended solely for use by the individual or entity to whom it is addressed.  If you have received this information in error, please notify the sender immediately and arrange for the prompt destruction of the material and any accompanying attachments.

--
You receive this message as a subscriber of the [email protected] mailing list.
To unsubscribe: mailto:[email protected]
For general help: mailto:[email protected]?subject=help
ObjectWeb mailing lists service home page: http://www.objectweb.org/wws