Re: Re: Problem adding cloned instructions

Hi Tronje,

the CheckClassAdapter can be used on a byte-array to analyze if it is correct.

The big problem is that I get a problem while generating the bytecode.

Do you know a solution for that?

On Sat, Nov 7, 2009 at 11:35 AM, Tronje Krop
<[email protected]> wrote:
> Hi Peter,
>
>> I'm encountering a problem (npe) while writing a class using the
>> classwriter with compute_frames option.
>>
>> What i'm doing is rewriting a method by inserting cloned instructions
>> where labels and labelnodes are also completely cloned (so no
>> sharing). The big problem is that classwriter executed the visitmaxs
>> and this relies  on the frame of the cloned label and this frame is
>> null, so causing an npe
>>
>> So appearently i'm doing something wrong. Are there any special rules
>> how to clone a label / labelnode?
>
> I think you should try CheckClassAdapter in your rewriting pass
> to verify whether your produced bytecode is correct. That at least
> was the hint helped me last time getting an NPE in ClassWriter.
>
> I actually included the CheckClassAdapter in every debugging run
> afterwards when running in develop-mode to have more verbose output
> of errors. If this does not help to catch the error you should re-
> visit the code by TraceClassVisitor. Last time debugging, I had the
> feeling CheckClassAdapter does not catch every problem adequately,
> but may although have been my problem.
>
> CU Tronje
>
>
> --
> You receive this message as a subscriber of the [email protected] mailing list.
> To unsubscribe: mailto:[email protected]
> For general help: mailto:[email protected]?subject=help
> OW2 mailing lists service home page: http://www.ow2.org/wws
>
>

-- 
You receive this message as a subscriber of the [email protected] mailing list.
To unsubscribe: mailto:[email protected]
For general help: mailto:[email protected]?subject=help
OW2 mailing lists service home page: http://www.ow2.org/wws