Re: Digest for [email protected] - 2 updates in 1 topic

Hi Max,
I agree with Patrick.
You could also try out the -nodisplay option and put it into the
robocode.sh file. As far as I remember, this will automatically set
-Djava.awt.headless=true internally in Robocode.

Read more about command line options for Robocode here:
http://robowiki.net/wiki/Robocode/Console_Usage

Best regards,
- Flemming

lør. 4. feb. 2017 kl. 21.09 skrev <[email protected]>:

> [email protected]
> <https://groups.google.com/forum/?utm_source=digest&utm_medium=email#!forum/robocode/topics> Google
> Groups
> <https://groups.google.com/forum/?utm_source=digest&utm_medium=email/#!overview>
> <https://groups.google.com/forum/?utm_source=digest&utm_medium=email/#!overview>
> Topic digest
> View all topics
> <https://groups.google.com/forum/?utm_source=digest&utm_medium=email#!forum/robocode/topics>
>
>    - Run the setup in a headless environment
>    <#m_4963614562810672680_group_thread_0> - 2 Updates
>
> Run the setup in a headless environment
> <http://groups.google.com/group/robocode/t/6926c2e7316de0b0?utm_source=digest&utm_medium=email>
> [email protected]: Feb 04 05:57AM -0800
>
> Hey,
>
> is there any way of running the setup jar in a headless environment? In my
> case a linux server or even a docker container. Im doing some test with
> genetic algorithms.
>
> Best regards,
> Max Noppel
> Patrick Cupka <[email protected]>: Feb 04 11:45AM -0500
>
> Maybe passing -Djava.awt.headless=true to the JVM will help? I have that in
> my notes to add to the default properties in RoboRunner and a couple people
> have mentioned it on the wiki. There's an old thread about it here:
>
> http://robowiki.net/wiki/Thread:User_talk:Beaming/what_to_do_with_about_printing_to_much%3F
>
> Also, I don't think you need to run setup, if that's the piece requiring a
> display - you can just copy the installed dir over to the server. I'd just
> clear config/robocode.properties to let the CPU constant recalculate.
>
> Hope that helps - good luck.
>
> On Sat, Feb 4, 2017 at 8:57 AM, noppelmax via robocode <
>
> --
> Patrick Cupka, [email protected]
> --
> Back to top <#m_4963614562810672680_digest_top>
> You received this digest because you're subscribed to updates for this
> group. You can change your settings on the group membership page
> <https://groups.google.com/forum/?utm_source=digest&utm_medium=email#!forum/robocode/join>
> .
> To unsubscribe from this group and stop receiving emails from it send an
> email to [email protected].
>

-- 
You received this message because you are subscribed to the Google Groups "robocode" group.
To unsubscribe from this group and stop receiving emails from it, send an email to [email protected].
For more options, visit https://groups.google.com/d/optout.