Re: PSTN to IP(H323) call routing

Muhammad,

You need an H.323 <-> PSTN gateway. JTAPI is only a control API and can't help in actually
getting the voice signal from one protocol to another. If you do find a gateway and two
JTAPI providers for each voice "fabric" or "protocol", GJTAPI has a multiplexor provider
that can be used to control both JTAPI providers as if they are one...


Richard

--
Richard Deadman
Deadman Consulting, Inc.
Web Services, Policy Management, Java Telephony, Software Architecture
mailto:[email protected]
http://www.deadman.ca
Office: 613-231-5112
Cell: 613-220-2469

On Dec 19, zeshan <[email protected]> wrote:
>
> Hi Every one,
>                         I have done the Incoming calls , outgoing calls ,
> DTMF and file playing on PSTN using JTapi.
> Further i am using a dilogic card D/PCI .
> I have also handle the call for H323 in Jtapi by using XTapi (only calls).
>
> now i want to integrate these two seperate modules (i.e PSTN and H323).
> i want that ,,when a call receive on PSTN ,i want to route it on H323 phone
> i.e to H323 IP phone
>
> what should i do? Help is required
>
> Thanks and Regards
> Muhammad Zeshan
>
> ===========================================================================
> To unsubscribe, send email to [email protected] and include in the body
> of the message "signoff JTAPI-INTEREST".  For general help, send email to
> [email protected] and include in the body of the message "help".
>

===========================================================================
To unsubscribe, send email to [email protected] and include in the body
of the message "signoff JTAPI-INTEREST".  For general help, send email to
[email protected] and include in the body of the message "help".