Re: trying to install kdebase3 on an imac G5

Sorry about that.  I should have been more specific.  I am using
darwinports.  I am trying to install kde using the following command:

port install kde

I had thought it was due to me trying to install, failing, and doing anothe=
r:

port -d selfupdate

I then decided to bring everything back to the beginning by deleting
all of /opt/local and installing darwinports again, updated to the
current again, and  running it again.  I get the same error.
I saw that it was looking for the kde-plugins, so I added that
directory under qtconfig.  That didn't seem to help either.

On 10/10/05, Benjamin Reed <[email protected]> wrote:
> On 10/10/05, Chuck MacKinnon <[email protected]> wrote:
> > I keep getting the following error:
> >
> > checking if UIC has KDE plugins available... no
> > configure: error:
> > you need to install kdelibs first.
> >
> > If you did install kdelibs, then the Qt version that is picked up by
> > this configure is not the same version you used to compile kdelibs.
> > The Qt Plugin installed by kdelibs is *ONLY* loadable if its the
> > same Qt version, compiled with the same compiler and the same Qt
> > configuration settings.
> >
> > I have completely removed all of the darwinports and started again.
> > It always comes back to this however.
> >
> > Any suggestions would be most welcome.
>
> kdebase3 where?  fink?  dports?  manual?  what version?
>