Re: trying to install kdebase3 on an imac G5

This is a DarwinPorts question. This list, KDE-Darwin, is about an  
entirely separate (and currently hibernating) project. See http:// 
darwinports.opendarwin.org to register for the DarwinPorts mailing  
list. I'm sure someone on that list can help you.


On Oct 11, 2005, at 8:57 AM, Chuck MacKinnon wrote:

> Sorry about that.  I should have been more specific.  I am using
> darwinports.  I am trying to install kde using the following command:
>
> port install kde
>
> I had thought it was due to me trying to install, failing, and  
> doing another:
>
> port -d selfupdate
>
> I then decided to bring everything back to the beginning by deleting
> all of /opt/local and installing darwinports again, updated to the
> current again, and  running it again.  I get the same error.
> I saw that it was looking for the kde-plugins, so I added that
> directory under qtconfig.  That didn't seem to help either.
>
> On 10/10/05, Benjamin Reed <[email protected]> wrote:
>
>> On 10/10/05, Chuck MacKinnon <[email protected]> wrote:
>>
>>> I keep getting the following error:
>>>
>>> checking if UIC has KDE plugins available... no
>>> configure: error:
>>> you need to install kdelibs first.
>>>
>>> If you did install kdelibs, then the Qt version that is picked up by
>>> this configure is not the same version you used to compile kdelibs.
>>> The Qt Plugin installed by kdelibs is *ONLY* loadable if its the
>>> same Qt version, compiled with the same compiler and the same Qt
>>> configuration settings.
>>>
>>> I have completely removed all of the darwinports and started again.
>>> It always comes back to this however.
>>>
>>> Any suggestions would be most welcome.
>>>
>>
>> kdebase3 where?  fink?  dports?  manual?  what version?
>>
>>
> _______________________________________________
> KDE-Darwin mailing list
> [email protected]
> http://www.opendarwin.org/mailman/listinfo/kde-darwin
>
>