Re: Python Error with Postfix queue filling up

Mat Cantin <[email protected]>
Newsgroups gmane.comp.kde.devel.kolab
Message-ID <1e4e951022fefc0afe19bfcea6ad9bcf__11919.8056673214$1362789498$gmane$org@cantinbrothers.ca>
On 2013-03-07 23:54, Paul Klos wrote:
> Mat Cantin schreef op 08-03-2013 2:19:
>> On 2013-03-06 0:38, Paul Klos wrote:
>>> 
>>> The message contains a 0xbb character that wallace is choking on.
>>> 
>>> I've had some similar errors, and just for laughs changed these
>>> characters into something else using hexedit, after which the mails
>>> went
>>> through without problems. For now, I have disabled wallace on my
>>> Kolab
>>> instance.
>>> 
>>> This is bug https://issues.kolab.org/show_bug.cgi?id=1627.
>>> 
>> 
>> This is exactly my problem. Interestingly, as described in the
>> comments
>> of this bug report, I tried to disable wallace in the master.cf file
>> and
>> the flush the postfix queue, but the wallace python error still 
>> showed
>> up and the error in the log still showed the email being delivered to
>> port 10026. Are these emails destined to go to wallace now that they
>> are
>> in the queue?
>> 
>> I guess my lack of postfix knowledge is showing. :-P
>> 
>> --
>> Mat
>> 
> Disabling Wallace will indeed only help for new messages. If you look
> at the messages in the deferred queue (/var/spool/postfix/deferrred),
> you'll see that it contains a complete destination address, including
> port 10026 (somewhere at the top of the file). I don't know if there's 
> a
> 'proper' way to inspect these messages, but a simple less will show 
> you
> this, despite a warning about a possible binary file.
> 
> So, I was expecting these messages to remain in the queue, and I was
> planning to leave them there and use them as test cases when I enable
> wallace again after this bug has been fixed. The mysterious thing is
> that my queue is now empty. I checked after this problem was posted to
> the list.
> 
> I did at some point restart postfix, maybe that has something to do
> with it. Or maybe postfix just gives up on these messages after a 
> while.
> 
> Cheers,
> 
> Paul
> 

Does wallaced have a log file? In the main maillog I notice emails come 
in and then get sent to 10026 (wallaced), but I can't seem to track them 
any further than that.

Thanks.
--
Mat
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.