Re: 3D printed KDE Keychains

Now it's better? :)
I will print in black, blue, white and red. =)
Cheers,

On Mon, May 16, 2016 at 5:28 AM, Kenny Duffus <[email protected]> wrote:

> On Sunday, 15 May 2016 18:23:28 BST Lays Rodrigues wrote:
> > The K that I used is from the logo that I found on the internet. But I
> > will make one new here =)
> > Thanks for the tip Sandro!
>
> The SVG of Lineart Simple is probably a good place to start
>
> https://www.kde.org/stuff/clipart.php
>
> --
>
>         Kenny
>
> _______________________________________________
> This message is from the kde-promo mailing list.
>
> Visit https://mail.kde.org/mailman/listinfo/kde-promo to unsubscribe, set
> digest on or temporarily stop your subscription.
>



-- 
*--*
*Lays Rodrigues*
*Front End Developer at Br-Print3D*
*Computer Science Student at Federal Fluminense University*
*brprint3d.wordpress.com <http://brprint3d.wordpress.com>*
*laysrodriguesdev.wordpress.com <http://laysrodriguesdev.wordpress.com>*
*fb.com/laysrodrigues147 <http://fb.com/laysrodrigues147>*
*Telegram @lays147*
*IRC lays147*


_______________________________________________
This message is from the kde-promo mailing list.

Visit https://mail.kde.org/mailman/listinfo/kde-promo to unsubscribe, set digest on or temporarily stop your subscription.