Re: 3D printed KDE Keychains
Albert Astals Cid <[email protected]>
| Newsgroups | gmane.comp.kde.events |
|---|---|
| Message-ID | <1923722.s5jiUrchNg@xps> |
El dilluns, 16 de maig de 2016, a les 12:22:38 CEST, Lays Rodrigues va escriure: > Now it's better? :) Looks nice, seems like some of the "connections" are a bit thin so it will probably break easily? Have you printed/tested any? Cheers, Albert > I will print in black, blue, white and red. =) > Cheers, > > On Mon, May 16, 2016 at 5:28 AM, Kenny Duffus <[email protected]> wrote: > > On Sunday, 15 May 2016 18:23:28 BST Lays Rodrigues wrote: > > > The K that I used is from the logo that I found on the internet. But I > > > will make one new here =) > > > Thanks for the tip Sandro! > > > > The SVG of Lineart Simple is probably a good place to start > > > > https://www.kde.org/stuff/clipart.php > > > > -- > > > > Kenny > > > > _______________________________________________ > > This message is from the kde-promo mailing list. > > > > Visit https://mail.kde.org/mailman/listinfo/kde-promo to unsubscribe, set > > digest on or temporarily stop your subscription. _______________________________________________ This message is from the kde-promo mailing list. Visit https://mail.kde.org/mailman/listinfo/kde-promo to unsubscribe, set digest on or temporarily stop your subscription.