Re: 3D printed KDE Keychains
Alexander Potashev <[email protected]>
| Newsgroups | gmane.comp.kde.events |
|---|---|
| Message-ID | <CADMG6+_spM9b533Vt99RXzjcVGwCWT3+6a+cH3ie3Wo+CH+BqQ@mail.gmail.com> |
2016-05-17 0:43 GMT+03:00 Albert Astals Cid <[email protected]>: > Looks nice, seems like some of the "connections" are a bit thin so it will > probably break easily? This can be fixed by making the logo an embossing, not a through-hole. -- Alexander Potashev _______________________________________________ This message is from the kde-promo mailing list. Visit https://mail.kde.org/mailman/listinfo/kde-promo to unsubscribe, set digest on or temporarily stop your subscription.