Re: Incorrect behavior in case of watchpoint

On Mon, Aug 21, 2017 at 1:54 PM, Aleksey Midenkov <[email protected]> wrote:
> I've set watchpoint with command `watch -l` and it was saved in
> KDevelop session. Now it doesn't start debug session because it ends
> up in endless loop:
>
> (gdb) 2106-break-watch "-location m_part_spec.start_part"
> 2106^error,msg="-break-watch: Unknown option ``location
> m_part_spec.start_part''"
> (gdb) 2107-break-watch "-location m_part_spec.start_part"
> 2107^error,msg="-break-watch: Unknown option ``location
> m_part_spec.start_part''"
> (gdb) 2108-break-watch "-location m_part_spec.start_part"
> 2108^error,msg="-break-watch: Unknown option ``location
> m_part_spec.start_part''"
> (gdb) 2109-break-watch "-location m_part_spec.start_part"
> 2109^error,msg="-break-watch: Unknown option ``location
> m_part_spec.start_part''"
> (gdb) 2110-break-watch "-location m_part_spec.start_part"
> 2110^error,msg="-break-watch: Unknown option ``location
> m_part_spec.start_part''"
> ...
>
> Though I've managed to delete breakpoint from Breakpoints tab and start again.

Hey Aetf,
Any idea why that could be?

Aleix

PS: Aleksey, can you make sure this is reported in bugs.kde.org?