Re: Incorrect behavior in case of watchpoint

Hi,

I'm afraid I don't have much time for this at the moment. Actually this has
been on my todo list for a while... I'll take a look at it soon.

Cheers,
Aetf

On Fri, Sep 1, 2017 at 7:55 AM Aleix Pol <[email protected]> wrote:

> On Mon, Aug 21, 2017 at 1:54 PM, Aleksey Midenkov <[email protected]>
> wrote:
> > I've set watchpoint with command `watch -l` and it was saved in
> > KDevelop session. Now it doesn't start debug session because it ends
> > up in endless loop:
> >
> > (gdb) 2106-break-watch "-location m_part_spec.start_part"
> > 2106^error,msg="-break-watch: Unknown option ``location
> > m_part_spec.start_part''"
> > (gdb) 2107-break-watch "-location m_part_spec.start_part"
> > 2107^error,msg="-break-watch: Unknown option ``location
> > m_part_spec.start_part''"
> > (gdb) 2108-break-watch "-location m_part_spec.start_part"
> > 2108^error,msg="-break-watch: Unknown option ``location
> > m_part_spec.start_part''"
> > (gdb) 2109-break-watch "-location m_part_spec.start_part"
> > 2109^error,msg="-break-watch: Unknown option ``location
> > m_part_spec.start_part''"
> > (gdb) 2110-break-watch "-location m_part_spec.start_part"
> > 2110^error,msg="-break-watch: Unknown option ``location
> > m_part_spec.start_part''"
> > ...
> >
> > Though I've managed to delete breakpoint from Breakpoints tab and start
> again.
>
> Hey Aetf,
> Any idea why that could be?
>
> Aleix
>
> PS: Aleksey, can you make sure this is reported in bugs.kde.org?
>