RE: Reply msg linkage info
"Bob Cozzi" <[email protected]>
| Newsgroups | gmane.comp.lang.as400.mi |
|---|---|
| Message-ID | <[email protected]> |
Use the msgkey (message key) to send a reply to the message. Doesn't matter where it is on the system, once you have the key, you can reply to it directly. -Bob Cozzi www.RPGxTools.com RPG xTools - Enjoy programming again. -----Original Message----- From: mi400-bounces-Zwy7GipZuJhWk0Htik3J/[email protected] [mailto:mi400-bounces-Zwy7GipZuJhWk0Htik3J/[email protected]] On Behalf Of M. Lazarus Sent: Saturday, September 10, 2005 8:54 PM To: MI Programming on the AS400 / iSeries Subject: [MI400] Reply msg linkage info Once I have retrieved a *RPY (any variety) message, is there a way to directly link to its corresponding the *INQ message? How does IBM do it when viewing a *MSGQ's messages? If this info is available, I would appreciate some sample code. If possible, RPG using the appropriate MI built-ins, since this info does not seem to be available via traditional means. TIA. -mark _______________________________________________ This is the MI Programming on the AS400 / iSeries (MI400) mailing list To post a message email: MI400-Zwy7GipZuJhWk0Htik3J/[email protected] To subscribe, unsubscribe, or change list options, visit: http://lists.midrange.com/mailman/listinfo/mi400 or email: MI400-request-Zwy7GipZuJhWk0Htik3J/[email protected] Before posting, please take a moment to review the archives at http://archive.midrange.com/mi400. _______________________________________________ This is the MI Programming on the AS400 / iSeries (MI400) mailing list To post a message email: MI400-Zwy7GipZuJhWk0Htik3J/[email protected] To subscribe, unsubscribe, or change list options, visit: http://lists.midrange.com/mailman/listinfo/mi400 or email: MI400-request-Zwy7GipZuJhWk0Htik3J/[email protected] Before posting, please take a moment to review the archives at http://archive.midrange.com/mi400.