RE: Reply msg linkage info
"M. Lazarus" <[email protected]>
| Newsgroups | gmane.comp.lang.as400.mi |
|---|---|
| Message-ID | <[email protected]> |
Bob, The objective is not to reply to the message, but to identify the message that the reply belongs to. The *INQ and *RPY messages have different message keys and I can't seem to locate the *INQ key embedded in the *RPG message. -mark At 9/11/05 10:19 AM, you wrote: >Use the msgkey (message key) to send a reply to the message. Doesn't matter >where it is on the system, once you have the key, you can reply to it >directly. > >-Bob Cozzi >www.RPGxTools.com >RPG xTools - Enjoy programming again. > >-----Original Message----- >From: mi400-bounces-Zwy7GipZuJhWk0Htik3J/[email protected] [mailto:mi400-bounces-Zwy7GipZuJhWk0Htik3J/[email protected]] On >Behalf Of M. Lazarus >Sent: Saturday, September 10, 2005 8:54 PM >To: MI Programming on the AS400 / iSeries >Subject: [MI400] Reply msg linkage info > > Once I have retrieved a *RPY (any variety) message, is there a way to >directly link to its corresponding the *INQ message? How does IBM do it >when viewing a *MSGQ's messages? > > If this info is available, I would appreciate some sample code. If >possible, RPG using the appropriate MI built-ins, since this info does not >seem to be available via traditional means. TIA. > > -mark _______________________________________________ This is the MI Programming on the AS400 / iSeries (MI400) mailing list To post a message email: MI400-Zwy7GipZuJhWk0Htik3J/[email protected] To subscribe, unsubscribe, or change list options, visit: http://lists.midrange.com/mailman/listinfo/mi400 or email: MI400-request-Zwy7GipZuJhWk0Htik3J/[email protected] Before posting, please take a moment to review the archives at http://archive.midrange.com/mi400.