Re: Kylix 3 Open Edition frozen?

no. it still frezes when the open dialog shows up. this time when
trying to install a new package, i selected browse and the frozen
kylix....
where can i go in borland to place this question?

--- In KylixGroup@y..., Adam Starkey <adam@s...> wrote:
> On Tuesday 27 August 2002 03:36 am, urifrid wrote:
> > Hi everyone, after some work i managed to download kylix 3 open
> > edition (over 300mb), after installing it i ran the delphi ide (kylix
> > ships with c++ builder now, there's to start scripts) and the 1st time
> > was clean and ok, the next time, i tried opening a project and kylix
> > froze.
> > i killed it and opening it again, then i went to open a project and it
> > froze again.
> > i restarted X, just to be sure. same in here.
> > i rebooted, sama in here.
> >
> > if i work with the blank project that kylix gives when it starts then
> > it works very well. as soon as i tried to open a project then it
crashes.
> >
> > i've been trying to get a solution, i tried freeing memory, i tried
> > running kylix passing as a command line the project file...
> > anyone got the same problem?
> > any workaround?
> >
> 
> Did you uninstall the old version before installing the new?  I had
trouble 
> with Kylix3 at first, but a clean install seemed to fix it.
> 
> I can't recall what the problem was (it's too early in the morning
still), but 
> some resource files seem to have moved between versions, and I think
I was 
> getting conflicts.  
> 
> -- 
> adam