Re: How to recreate the 31 July color.com
"John Comeau" <[email protected]>
| Newsgroups | gmane.comp.lang.forth.colorforth |
|---|---|
| Message-ID | <[email protected]> |
Hi Jason, the color.com file is what was saved after loading the high-level colorForth code, so it has a lot more data in the lookup tables than does the bare-bones code assembled from the sources. Also, the sources have a glaring off-by-one error that causes code to load at the wrong location, hence Charley's advice might work. But even running it as a DOS program won't help if you don't have exactly the right hardware. You might need to use a different colorForth compiled for your own graphics card. On Fri, Feb 22, 2008 at 11:14 AM, <[email protected]> wrote: > I vaguely remember that what was created with an assembler had to be run from a DOS boot disk. In other words, it's a DOS program, not a native colorforth. Am I wrong? Then when and if it runs you can save it as a native colorforth floppy with SAVE. > > I hope that helps, > Charley. > > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [email protected] > For additional commands, e-mail: [email protected] > Main web page - http://www.colorforth.com > > -- John Comeau <[email protected]> http://jc.unternet.net/ "A place for everything, and everything all over the place"