Re: colorforth 2.0a for stand-alone and Windows use

On Mon, May 19, 2008 at 6:50 PM, Josef Gabriel <[email protected]> wrote:
> On 5/9/08, Ray St. Marie <[email protected]> wrote:
>> On Fri, May 9, 2008 at 10:24 AM, Josef Gabriel <[email protected]> wrote:
>> > Jeff,
>> >
>> > Great work with the new release.
>> >
>> > To all,
>> >
>> > I am using the windows wrapped version. load nor loads work on my
>> > computer. I am not sure how to fix this. Since whiting out qwerty
>> > worked, I tried to just add "88 load" to block 18. That did not seem
>> > to work. Any suggestions?
>> >
>> > Thank you,
>> > Josef
>> >
>>
>> Hi Josef. Gotta question for you. When you added 88 load to block 18
>> did you "warm" boot so that block 18 would be re-loaded with your new
>> word?
>>
>>
>> Best of luck
>> Ray
>
> Ray,
>
> I tried something similar to that. CF ended up booting to a black
> screen. I deleted the copy I had and uninstalled. Load works fine now.
> I suspect I cut something while I was looking at the source. I'll try
> and do better evidence collection if it happens again.
>
> Thank you,
>
> Josef
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: [email protected]
> For additional commands, e-mail: [email protected]
> Main web page - http://www.colorforth.com
>
>

Thank you for sharing your experience here on the list, Josef. I
appreciate it. Very much. The more that participate the more can
participate. :-)

Ray

-- 
Raymond St. Marie ii,
colorforthray.info