Re: system error code 1073740940, UMAT subroutine

Did you check the files?

Mehdi Hamid [email protected] [Abaqus] <[email protected]> schrieb
am So., 29. Juli 2018, 15:04:

>
>
> Dear All,
>
> I am encountering an error while trying to run a umat in abaqus. The error
> is as the following:
>
> Error in job Job-1: The executable standard.exe aborted with system error
> code 1073740940. Please check the .dat, .msg, and .sta files for error
> messages if the files exist.  If there are no error messages and you cannot
> resolve the problem, please run the command "abaqus job=support
> information=support" to report and save your system information.  Use the
> same command to run Abaqus that you used when the problem occurred.  Please
> contact your local Abaqus support office and send them the input file, the
> file support.log which you just created, the executable name, and the error
> code.
>
> The error happen after showing a message that analysis input file
> processor completed successfully.
>
> I am not sure how to debug the code for this error. Any help is
> appreciated.
>
> Thanks,
> Mehdi
> 
>