Re: 3D Hashin failure criterion

Hello


a subroutine code for the Hashin criterion is available from
"FINITE ELEMENT ANALYSIS OF CARBON FIBER COMPOSITE RIPPING USING ABAQUS"
A Thesis Presented to the Graduate School of Clemson University
In Partial Fulfillment of the Requirements for the Degree Master of 
Science Mechanical Engineering
by Joy Pederson
December 2006

Little known are ABAQUS built-in models, see
http://imechanica.org/node/18733
The following might appeal to you:
VUMAT Continuum damage model for fabric reinforced composites
VUMAT Damage and failure in unidirectional fiber composite materials


Good luck

Frank



Am 29.07.2018 um 15:07 schrieb Amir Molavizadeh [email protected] [Abaqus]:
> Hi, I did some projects about composite materials. I remember two or 
> three of them were about 3d hashin Criterion. You should use Umat 
> subroutine.
>
> On Mon, 26 Dec 2016, 18:05 Moeen Saeed [email protected] 
> <mailto:[email protected]> [Abaqus], <[email protected] 
> <mailto:[email protected]>> wrote:
>
>     Hi,
>
>     I would like to ask if there is any one in the group who used 3D
>     Hashin failure criterion? Or in general any progressive failure
>     criterion for composite laminates using solid elements?
>
>     Regards
>     Moeen
>
>     [Non-text portions of this message have been removed]
>
>